A Dohlman Lab Protocol
Pheromone Halo Assay
REFERENCE: Hoffman, G., Garrison, T. R., and Dohlman, H. G.,
Analysis of RGS proteins in Saccharomyces cerevisiae, Methods
-Use sterile technique and sterile solutions throughout this method.-
1. Grow a starter culture at 30 C with shaking (250 rpm) until it reaches saturation.
***It is important to make sure all strains to be tested are completely saturated, since cell density can affect the size of the halo.
2. Microwave a sterilized solution of 0.5 % agar until melted and place in a 55 C water bath.
***Don't leave unattended when microwaving since the agar tends to boil over suddenly.
***Make sure the agar equilibrates to 55 C to 60 C before starting the assay; otherwise it will kill the cells.
3. Distribute several paper disks (Difco, #1599-33-6) into a sterile petri dish, and spot either 5 or 15 of synthetic alpha-factor (1 - 5 mg/ml) onto each disk.
***In some instances, it may be beneficial to use more disks per plate to obtain a wider range of alpha-factor concentrations.
***This should be done no more than 1 to 2 hrs before use.
4. Aliquot 4 ml of 0.5 % agar into a 5 or 14 ml plastic tube with a pop-off cap (e.g. Falcon, #35-2063).
5. Immediately before performing the assay, transfer a small volume of the saturated starter culture into the tube containing agar. 100 ul of starter culture should be used for strains grown in SCD; 10 ul should be used for strains grown in YPD.
6. Invert a few times, and pour onto a pre-warmed plate containing the appropriate solid media. Swirl to cover the plate evenly. This step should be done quickly to prevent the agar from solidifying.
***It is convenient to do two tubes at a time, one in each hand.
***Bubbles can usually be eliminated by poking with flamed sterile forceps.
7. On the plate, place one paper disk containing 5 ul alpha-factor, and one disk containing 15 ul alpha-factor.
***When doing several assays, it is helpful to use a paper template for consistent placement of the disks on each plate.
8. Place the plate at 30 C until a lawn of cells appears. The halo assay will result in a zone of growth inhibition surrounding the filters soaked with pheromone, as seen in the example below. Halos can usually be seen clearly after 24 hrs for most strains.
***It is often desirable to let the cells grow longer (up to several days) to get a denser lawn and to observe any changes that might occur over an extended period of time.
9. Differences in halo size are normally big enough to be detected by eye.
***It is also possible to measure halo
size and plot this value vs. log [alpha-factor].
Back to Research
Back to Dohlman Lab Home Page